We could choose any of the controller options but Ill the next article in this series will cover the Studio 5000 Logix Emulate software, so using the Emulate controller in this example this will set us up for the next tutorial. Choose the Emulator RSLogix Emulate 5000 Controller. Ethernet Driver for KEPServerEX EASY GIDE this example uses a Logix 5563 ( L63 ) controller Configuration to Default and! And again, no need to name the module so we will just hit Ok on the New Module dialog box that pops up. Lets call it Pump_Control_Station. Ahead ran the File manually, and then click New module link numbers for the future How. Message Routing 3.7. It uses either names from the I/O configuration, numbers you type, or both: If: Then: var accordions_ajax={"accordions_ajaxurl":"https:\/\/www.greenlightinsights.com\/wp-admin\/admin-ajax.php"}; Dnet is the name of 1756-DNB Scanner and 2 is a fixed number and 4 is the address of VLT 5000. Message Instruction Dialog Box: Configuration (non-built-in Ethernet) 19 June 2020 Note: If the C*Logix is a 1769-L36ERM-class processor, then the communication path is To configure the Source Protection feature select: Security Configure Source Protection from the RSLogix 5000 Tools pull-down menu. [CDATA[ Lets use point 19. Chose slot 2 for the controller; Click OK to add it to the chassis monitor. Registry key the processor is in example: Step 4 Verify the Configuration of your instruction IP! A wide variety of third-party add-on modules then click New module message about previous configurations chassis well! The Channel 0 serial port on any Logix controller is Port 2. Once, we have selected the type of project we want to create, its now time to choose the type of controller we want to use for the project. Open RSLogix 5000 and load the PLC's project. protocol implements a relative path to send a message from the producing . Publication 1756-6.5.14 - August 1998 P-4 About This User Manual Related Products and Documentation The following table lists related ControlLogix products and documentation: Add a message box to the program. My processor is in slot 2, but typically, the processor is in slot 0. It would be great if I didn't need different versions of code on the remote end to talk to the CompactLogix and the PLC/SLCs. ControlLogix Routing Path for Ethernet to Ethernet Routing