\n<\/p>
\n<\/p><\/div>"}, {"smallUrl":"https:\/\/www.wikihow.com\/images\/thumb\/9\/96\/Fix-Vape-Pen-Wires-Step-12-Version-2.jpg\/v4-460px-Fix-Vape-Pen-Wires-Step-12-Version-2.jpg","bigUrl":"\/images\/thumb\/9\/96\/Fix-Vape-Pen-Wires-Step-12-Version-2.jpg\/aid9649466-v4-728px-Fix-Vape-Pen-Wires-Step-12-Version-2.jpg","smallWidth":460,"smallHeight":345,"bigWidth":728,"bigHeight":546,"licensing":"
\u00a9 2023 wikiHow, Inc. All rights reserved. Accidentally dropping liquid here may cause you to inhale the e-liquid in its liquid form. Take a bottle of e-liquid and place a bit of juice on each of the coil's wick openings until you no longer see dry cotton. This image is not<\/b> licensed under the Creative Commons license applied to text content and some other images posted to the wikiHow website. How to Take Apart a Vape Tank - Vape Juice From the many already built-in parts to the extra technology you add, the little nooks and crannies of your box mod that you need to take care of add up quickly. In most cases, disassembling a vape tank is a simple task that you can perform in a matter of seconds. Remove the coil from the bottom. Its as yet an extraordinary passage point for potential vapers who are going to make their entrance into the universe of vaping. to take this opportunity to assure you that your safety and After youve enjoyed a good vape session, turn off your SMOK device by accessing the menu system again. Important Safety Information and Warnings. You must fill the Pod with e-liquid before using the ACRO device: 1) Open the slot on the pod by pulling back the rubber plug. Put a few drops of e-liquid directly onto the coil, fill up your tank, and then youre ready to vape. For more information, please see our This image may not be used by other entities without the express written consent of wikiHow, Inc.
\n<\/p>
\n<\/p><\/div>"}, {"smallUrl":"https:\/\/www.wikihow.com\/images\/thumb\/0\/05\/Fix-Vape-Pen-Wires-Step-14-Version-2.jpg\/v4-460px-Fix-Vape-Pen-Wires-Step-14-Version-2.jpg","bigUrl":"\/images\/thumb\/0\/05\/Fix-Vape-Pen-Wires-Step-14-Version-2.jpg\/aid9649466-v4-728px-Fix-Vape-Pen-Wires-Step-14-Version-2.jpg","smallWidth":460,"smallHeight":345,"bigWidth":728,"bigHeight":546,"licensing":"
\u00a9 2023 wikiHow, Inc. All rights reserved. There will most likely be about 6 holes for you to put drops into. The screen displays "MAG -18" and the version number, and then enters the main interface. No matter the look, they all make vapor in the same way. Each unit we would say went on for several weeks with some in any event, arriving at the 2-week point before there was a remarkable drop in flavor and fume yield. Begin by twisting same-colored wires together.